 |
||
|
|
||
| |||||||||||||||
|
|
 ERDC TN-DOER-T6
September 2004
surface is created by sand in the hopper as shown in Figure 7. Hopper sounding methods are
based on an averaged hopper load height. Sand volume is determined by averaging sand heights
measured directly under the transducers. The amount of error introduced by this loading
condition depends on the location and number of point measurements taken by sensors relative to
the sand deposition pattern (unevenness of the load's surface and respective elevations under the
sensors).
9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing |
